Archive for the ‘ 2010 ’ Category

Winch Gearing & Performance Calculations

See the linked PDF below, for some important calculations regarding gearing and performance of the winch.  The run-through of the basic calculations should be understandable by the astute high-school student.

Please let Dave know if there are any errors in the calculations, and it will be corrected accordingly.

winch_calcs

Final Ratios & Gearbox Info

Agreed Upon Specs:

2 Speed with Power-Take-Off (PTO) for Winch

4 CIM motors, 2 per side

Initial Reduction – 12:45

High Speed Reduction – 30:48  gives ~15.5 fps at 93% efficiency

Low Speed Reduction – 14:64 gives ~ 5.5 fps at 93% efficiency

All gears are AndyMark except for the 64 tooth dogged gear, 45 tooth intermediate gear, and the 30 tooth internediate gear, all of which are standard Martin gears.

The PTO shaft sits above the intermediate shaft and has one speed, and an the option for two with the addition of another three position piston.  We also have the option of disengaging the output to the wheels if we use another three position piston.

Options Clarified:

1. Wheels move when winch is engaged – two standard pistons required per gearbox

2. Wheels do not spin when winch is engaged – one standard piston, one three position piston

3. Wheels spin when winch is engaged, but winch now has 2 speeds – one standard piston, one three position piston

4. Wheels do not spin when winch is engaged, and winch has 2 speeds – two three position pistons

The cost of the three position pistons is ~$70.  The cost for the standard piston is ~$20.  The gearbox will be designed to accommodate any of these options without the need to change ratios, plates, shafts, etc.

Pictures from Manchester field

Link

Link2

Build Day 1 Meeting Minutes

  • Ideal design would utilize a  rigid 6 wheel / 8 wheel structure
  • Ideal design would also incorporate a mechanism that will allow the robot to traverse over bumps quickly
  • Both teams are wondering on the usage of 8″ inch wheels. (Additional gearing)
  • Recommended Protyping: Build 6″ wheel chassis on 6 wh/8 wh base
  • Didn’t discuss ball manipulation mechanism
  • Winching should be relatively easy
  • The transmission should be the most important part of this game
  • 254 disagrees to lifting up two other robots(Reasoning: 50 lbs of parts for 6 points)
  • 254 recommends that we should winch ourselves
  • 254 will test 8″ and 6″ diameter wheels on 06 bot.
  • 968 will do CAD on wheel base distance with various wheels and distance from center to center.